Harley Davidson Pan America Forum banner

1000 Mile Service Done!

906 Views 9 Replies 6 Participants Last post by  Burnin Padrons
3
I just finished doing my first service. The tank removal was not nearly as bad as I thought it was going to be. The bolt on the left side is a little tricky but other then that not too bad. My biggest struggle was getting to the main fuse, mine was not ran up to the access panel where it should be, the wire was too short and all the slack was down under the skid plate. I also changed out the air filter while I had the tank off. With the assistance of Mike's Motorbike Channel on YouTube Mike's Videos this was not as hard to do as I thought it would be. Thanks Mike for taking the time to make those videos!
Tire Wheel Fuel tank Plant Vehicle

Vehicle Hood Automotive tire Motor vehicle Automotive design

Automotive tire Motor vehicle Hood Automotive design Automotive exterior
See less See more
  • Like
Reactions: 5
1 - 2 of 10 Posts
I wonder if one raised the tank 1/2 an inch you could get more air flow i did it om my Aprilia RSV and that worked.
Not sure that's possible due to the fact that the two front tank bolts go in at an angle.
The inlet to the air box faces forward anyway
1 - 2 of 10 Posts
Top